Why does the C24x PWM block's documentation refers to the "Pulse Width" setting when it should refer to the "Duty Cycle" setting in Embedded Target for TI C2000?
1 view (last 30 days)
Show older comments
In the C24x PWM block's documentation page the term "Pulse Width" should be replaced by "Duty Cycle".
Accepted Answer
MathWorks Support Team
on 27 Jun 2009
This is an error within the documentation for Embedded Target for TI C2000 within the C24x PWM block's section.
The documentation should read as follows:
The value set in Duty Cycle above determines the value in the register.
0 Comments
More Answers (0)
Communities
More Answers in the Power Electronics Control
See Also
Products
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!