Image Acquisition Toolbox™ Support Package for Hamamatsu Hardware enables you to acquire images and video from Hamamatsu cameras directly into MATLAB® and Simulink®.
This support package is functional for R2014a to R2019b only.
For R2020a and higher releases, download the Image Acquisition Toolbox adaptor directly from Hamamatsu here:
I am having an issue with this toolbox: I have ORCA FUSION USB3 card, all the drivers are in place and the camera is working with hamamatsu software (HCImage) but Matlab2018b does not see the camera. However everything is fine in Matlab2019a, which I however cannot use due to other hardware issues. I would appreciate an advice concerning this issue.
Thank you in advance,
The Hamamatsu support package hosted on this page is compatible with MATLAB releases R2014a to R2019b only.
To use Hamamatsu adaptor with MATLAB releases R2020a or higher, you much install the adaptor from the Hamamatsu website.
Please refer to 'R2020a – current' section at the bottom of the following page for additional information.
Is this support package compatible with matlab 2020b? I faced an error installing it.
What camera model are you using? Are there other interfaces the camera supports for triggering?
To make this work In 2018b, I need to change the "Trigger Connector" property to "bnc" from the "Device property" tab in Image Acquisition Toolbox. The default value is "interface". I hope MATLAB will change the default value in the future version.
The code is
vid = videoinput('hamamatsu', 1, 'MONO16_2048x2048_FastMode');
src = getselectedsource(vid);
src.TriggerConnector = 'bnc';
but it does not work at 2018b.
Works great with ORCA D-II
Could you please make a mac compatible version?
Find the treasures in MATLAB Central and discover how the community can help you!Start Hunting!