Parameter display and tuning
Calibration data saving, restoring, and swapping by page
Signal value streaming
These tools run in XCP master mode. Simulink Real-Time emulates an electronic control unit (ECU) operating in XCP slave mode. To enable a real-time application to work with the third-party software:
Configure the third-party software to communicate with the real-time application as an ECU.
Provide a standard TCP/IP physical layer between the development and target computers. Simulink Real-Time supports third-party calibration software only through TCP/IP.
Generate a real-time application with signal and parameter attributes that are consistent with A2L (ASAP2) file generation. See Export ASAP2 File for Data Measurement and Calibration.
Use the build process to generate
model.a2l (ASAP2) files
that the software can load into its database. The generated file contains signal
and parameter access information for the real-time
XCP-related sections and memory addresses.
If your model includes referenced models, the build creates a
model.a2l file for the real-time
application and separate
refmodel.a2l files for each referenced model.
You cannot configure third-party software for calibration with only the A2L files that Simulink Coder™ generates. These files do not contain XCP-related sections and memory addresses. Simulink Real-Time adds this information during the build process.