Clear Filters
Clear Filters

Why do I get Coverage error .

7 views (last 30 days)
Shivam Singh
Shivam Singh on 20 Dec 2021
Commented: Garmit Pant on 9 Aug 2024
Why this error, Not able to highlight because model changed error during Coverage analysis
With every model I used.
  3 Comments
Ian
Ian on 9 Aug 2024
Hi Pat,
So when model have been changed, I need to create new harness then enable to doing coverage test?
Garmit Pant
Garmit Pant on 9 Aug 2024
Hi @Ian
The answer below can be helpful to you too.

Sign in to comment.

Answers (1)

Garmit Pant
Garmit Pant on 9 Aug 2024
Hi Shivam,
The problem you are encountering may be due to changes made in the model between multiple simulation runs. The Coverage Report can be aggregated over multiple coverage runs, but the model needs to remain unchanged for this to work correctly.
As of the latest version, R2024a, you can make changes between coverage runs, but the coverage results are generated and highlighted only for the runs with an unchanged model. If you try to include runs with a changed model, an error will be generated.
R2024a introduces new features to generate coverage reports over multiple simulations using Design Studies. Refer to the following resource to understand how to use this new feature: [Collect Coverage for Multiple Simulations](https://www.mathworks.com/help/slcoverage/ug/collect-coverage-for-multiple-simulations.html).
I hope you find the above explanation and suggestions useful!

Categories

Find more on Verification, Validation, and Test in Help Center and File Exchange

Products


Release

R2021a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!