powerlib_models problem help
Show older comments
when i try to use this smilinlk file this erro pop out
7 similar
Failed to load library 'powerlib_models' referenced by 'hybridpvwind/DC-DC chopper1/Voltage Measurement/model'.
Component:Simulink | Category:Model error
Failed to load library 'powerlib_models' referenced by 'hybridpvwind/PV/Voltage Measurement2/model'.
Component:Simulink | Category:Model error
Caused by: Too many output arguments.
Component:Simulink | Category:Model error
Component:Simulink | Category:Model error
Component:Simulink | Category:Model error
Error in 'hybridpvwind/Wind/Asynchronous Generator 480V 275kVA': Failed to evaluate mask initialization commands.
Caused by: Insufficient number of outputs from right hand side of equal sign to satisfy assignment.
Component:Simulink | Category:Model error
Failed to find 'spsAsynchronousMachineModel/Electrical model' in library 'spsAsynchronousMachineModel' referenced by 'hybridpvwind/Wind/Asynchronous Generator 480V 275kVA/Electrical model'
Component:Simulink | Category:Model error
Failed to find 'spsAsynchronousMachineModel/Mechanical model' in library 'spsAsynchronousMachineModel' referenced by 'hybridpvwind/Wind/Asynchronous Generator 480V 275kVA/Mechanical model'
5 Comments
Walter Roberson
on 3 Apr 2022
It sounds to me as if you might not have Simscape Electrical installed.
Bader Herzallah
on 4 Apr 2022
Mahmoud Ashraf
on 4 Apr 2022
i think you need to make sure the Simscape Electrical installed (As mr Walter noted).
then make sure that you use the powergui block with the correct parameters.
Bader Herzallah
on 8 Apr 2022
Walter Roberson
on 10 Apr 2022
Try reinstalling Simscape Electrical.
Answers (0)
Categories
Find more on Introduction to Installation and Licensing in Help Center and File Exchange
on 3 Apr 2022
on 10 Apr 2022
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
