I am facing problems when I build my model using the embedded coder support for launchpad f28379D. Error message that I see: "Code generation information file does not exist."

2 views (last 30 days)
Hi,
I have attached the screenshot. You may refer to it. I referred to this youtube tutorial by MathWorks to blink the LED on port 31.
I am unable to figure out the source of the problem although I followed all the steps perfectly.
Thankyou
Karthikeya

Answers (1)

Sanjana
Sanjana on 31 Oct 2023
Hi Karthikeya,
I understand that you are facing an issue when trying to build a model in embedded coder. The same issue is reported by other users over the community and as per the solutions suggested, the issue might be with the length of file path, as there is a limitation imposed by windows 10 to have a path length of maximum 260 characters including drive letter and colon.
I suggest you check if moving your file, to a shorter path location will resolve the issue.
Please refer to the following discussions over the community, to get more insight into the issue,
Hope this helps!

Products


Release

R2021b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!