How to use 'copy command' from MATLAB examples and implement it?

Hi,

I am trying to find a li-ion temperature dependent battery model for predicitive maintenance. I found this link - https://nl.mathworks.com/help/sps/ug/lithium-ion-temperature-dependent-battery-model.html

Here, I can see copy command but I am unable to figure out the later process.

How to use this copy compand in MATLAB Simulink for it to work?

Answer 1

[Cris LaPierre]

Copy the command, then paste it into your MATLAB Command Window and run it. That will automatically download and open the example in Simulink. Just give it a few seconds to do all that.

[Ashwini Rathi]

I tried it but it says unrecognized function.

I am using 2022a version

[Cris LaPierre]

Hmm. I was able to open it is R2022a.

Check that you have the following toolboxes installed:

• optimization_toolbox
• power_system_blocks
• simscape

If not, and they are included with your license, you can install them using the Add-Ons Explorer.

Note: You will likely need Simscape and Simscape Electrical. The list I shared is what MATLAB shows is in use after running the model.

Answer 2

[Huseein]

I am running into the same issue, when I paste the copied command, I will get an error in the Command Window!

[Huseein]

trying to run this model "PV Home On-Grid Solar System" from MathWorks library!

[Steven Lord]

What release of MATLAB are you using?

Does that example indicate that it was created in a later release than the one you're using?

Do you have the products that the example says it uses installed and licensed?

[Huseein]

Issue solved, I had to install the simscape library then load the model.