Do OPC-UA blocks in simulink work with code generation?
13 views (last 30 days)
Show older comments
Fredrik
on 27 Mar 2024
Commented: Fredrik
on 28 Mar 2024 at 7:24
If I set up my simulink controller to communicate through OPC-UA blocks can I then code-generate the controller and the opc-ua blocks into one deployable code package?
The goal is to deploy a controller that can run on its own in a container and also handle the OPC-UA communication.
0 Comments
Accepted Answer
Andreas Goser
on 28 Mar 2024 at 6:36
Not an expert here, but I found two new blocks as of R2024a here and here. Please confirm you a talking about those?
If yes, my viewpoint is they are not ready for code generation. My logic is that there is always a note about extended capabilities at the bottom of the page, see e.g. this Simulink block that says
Extended Capabilities
C/C++ Code Generation
Generate C and C++ code using Simulink® Coder™.
It is probably a good idea if you share your use case with MathWorks so an enhancement reqest can be created or you get linked to it. Technical Support is a good contact to submit enhancement ideas.
More Answers (0)
See Also
Categories
Find more on Communications Toolbox in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!