Problem when implementing trained TensorFlow Model in Simulink using the TensorFlow Model Predict block.

I have previously trained a TensorFlow model in python and I'm looking to implement it into Simulink, which I thought was supposed to be straight forward. However I ran into the following error where it says the output from the predict block is producing variable size signal (they are supposed to be all 1 by 1 float 32)

I don't understand what the problem may be. I have set the maximum Matlab dim size to 1s as the following.

Any Ideas what the problem might be?

[Gayathri]

Hi @Bevan Bintang, can you please provide the model and the trained model file so that I can look into the issue in detail

Answer 1

[aditi bagora]

Hi @Bevan Bintang,

It seems there might be a configuration issue between the 'Output_Port_1' of the bus selector and the 'Input_port_1' of the 'Moment_aft' subsystem. This could be due to the 'Tensorflow Model Predict' block generating a variable-size output, which the subsystem might not support or be configured to handle.

As @Gayathri suggested, to help resolve the issue, it would be beneficial if you could provide the necessary files.

Hope this helps!