problem with control using PID controller
Show older comments
I am using simulink and TI F28335 to implement close loop control logic via PID control. Inverter output voltage drops by 4V when i connect resistive load. How to overcome this? i am taking output voltage feedback to do control. Do i need output current feedback also?
1 Comment
ashish ahir
on 7 Sep 2015
Answers (0)
Categories
Find more on PID Controller Tuning in Help Center and File Exchange
Products
on 7 Sep 2015
on 7 Sep 2015
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
