Simulink Block not used.

Hello,

I am trying to make a Simulink Model, most of the blocks work properly, but some are "not used" as it says on the yellow labels. I want to know what it means that the block is "not used". As I already searched it says that "Simulink cannot obtain the signal value due to optimization." but i dont really understand how to solve the problem. The blocks already exist in the Simulink Library Browser.

Thank you

[Joanne Al-Adham]

Hi, did you figure out an answer to this?

Answer 1

[Hayder Gallas]

im facing the same problem, have you found a solution please !

Answer 2

[Eugene Ofori]

I had the same problem and turns out the message is correct. I fixed this in the past by forcing matlab to think you require the signal and stop it from ignoring it due to optimisation. Connecting the signal or another signal downstream that uses your signal of concern to a display or scope has worked in the past. For my case it actually alerted me that I had forgot to assign my signal to my output bus.