One variable, two 'To Workspace' blocks simulink
17 views (last 30 days)
Show older comments
Hello, is there a way to update single struct variable using two or more 'To Workspace' blocks at different locations in simulink (2017b) ??
2 Comments
Fangjun Jiang
on 2 Jul 2020
what do you mean "update"?
"struct" data type is not supported in Simulink.
Answers (1)
Fangjun Jiang
on 2 Jul 2020
"Res" is the variable created in the based workspace after simulation is done to log your simulation data
- You can't have two "To Workspace" blocks in the model with the same variable name "Res".
- You can log more than one signals to the same variable "Res" with just one "To Workspace" block. To do that, use a Mux block or Bus Creator block to combine all those signals together and then feed it to the "To Workspace" block. Observe the "Res" data after simulation to figure how to access the data inside it.
4 Comments
Fangjun Jiang
on 2 Jul 2020
Don't quite understand the use case of your particular saving format.
- Do post processing, combine out.Res and out.Res1 into out.Res
- Use global Goto/From block to avoid signl routing but Mux all the needed signals together
- Not to use "To Workspace" block, use individual signal logging by setting signal line properties, then post processing, combine signals by name, i.e. out.FrontWheelSpeed and out.RearWheelSpeed to out.WheelSpeed
See Also
Categories
Find more on Sources in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!