if else statement in simulink function

Hi everyone. I am trying to make a switch using function. V states for voltage and when it exceeds 50V on voltmeter, the d value must be switched to V. But in all my simulations it keeps to stay at d=Iold instead of d=Vold even though the voltage already exceeded 50V. Would appreciate your suggestions

Answer 1

[Gouri Chennuru]

Hi Arnur,

I recommend you to check the inputs to the function & configure the inports to the model & the output to the function call and use the MATLAB function block enable you to define custom functionality in Simulink where that function is implemented using MATLAB.

Thanks & Regards,

Gouri Chennuru.