program will not fit into available memory ".cinit"

20 views (last 30 days)
Good Afternoon,
I have a model which is configured to run on a TI 28355 DSP. The model builds without an issue and runs on the DSP.
I am looking at implementing some of the blocks as model references so that they can be individually tested and re-used, however i get the following compilation error
"C:/ProgramData/MATLAB/SupportPackages/R2020a/toolbox/target/supportpackages/tic2000/src/c28335.cmd", line 70: error: program will not fit into available memory. placement with alignment/blocking fails for section ".cinit" size 0x28a page 0. Available memory ranges: RAML0L3 size: 0x4000 unused: 0x284 max hole: 0x284 error: errors encountered during linking; "../Inverter_Cubicle_Control_ref.out" not built
What is the problem and how would I go about fixing it?

Accepted Answer

Venkatesh Chilapur
Venkatesh Chilapur on 2 Nov 2020
  1 Comment
Matthew Orford
Matthew Orford on 4 Nov 2020
Thanks for the response, I can't get the code to replicate the issue currently frustratingly.
The link you have sent should put me down the correct road

Sign in to comment.

More Answers (0)

Products


Release

R2020a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!