Community Profile

photo

Yash


Last seen: 2 months ago Active since 2022

Statistics

  • Knowledgeable Level 1
  • First Answer

View badges

Content Feed

View by

Answered
running simulink model on a ti c2000 mcu
Hi Kilaparthi, Try to install the dependencies and support packages again referring this video by MATLAB - https://youtu.be/rs...

5 months ago | 0

Answered
simulink TI C2000 F28035 Data monitoring
Hi Mustafa, I understand that you are not able to connect to a suitable port for reading data. I suggest you to go to the host ...

5 months ago | 0

| accepted

Answered
LAUNCHXL-F28379D: Need information regarding Digital DC/DC Buck Converter Using Peak Current Mode Control
Hi Pratyay, As per my knowledge f28379D Launchpad is used for voltage-mode control. If you want to implement peak current-mode ...

5 months ago | 0

Answered
Buck boost converter gate terminal is not connecting to pulse generator
Hi Satendra, In the attached screenshot I made a model of simple dc-dc buck converter, you can try to replicate the same. May b...

5 months ago | 0

Answered
Need information regarding Software implementation model for TI F28379D Launchpad with BOOSTXL-BUCKCONV
Hi Pratyay, The system initialization block is written for the code-gen variant of the model. If you want detailed description ...

5 months ago | 0

Answered
TMS320F28379D: Code Generation Error while Using CLA Task Trigger block in Simulink
You should connect a CLA_Subsystem with the CLATaskTrigger instead of using a function interrupt. Checkout the code-gen variant ...

5 months ago | 0

Answered
TI C2000, To workspace always gives last value.
You can use a data store memory in Simulink. You can refer to the article from the link given below. Define data store - Simul...

5 months ago | 0

Answered
Simulink &TI f28379d ADC configuration
To get a stable output you can use a relay block available in Simulink. This may help you to get a stable value within the range...

5 months ago | 0

Answered
changing hardware board to F280379D for embedded coding using matlab R2021b
Probably you made a copy of a file and made changes in the new one and tried to simulate it. Either change the name of the new f...

5 months ago | 0

Answered
developing an embedded target
For embedded targets, you can probably make a simulation variant, but the code-gen variant will probably come from MW because fo...

5 months ago | 0

Answered
Unknown error using Simulink with Lego EV3
Check for the installation of the dependencies, if build failure sustains then it would be great if you could share a screenshot...

5 months ago | 0